FreeCommander Forum

Hello,

I am using the last donor release (Build 731 64-bit donor, Windows 10 Anniversary Update) and the issue I already reported here is always reproducible.

Since a lot of version, I notice sometime a problem when I go back on the parent folder.
On the attached screenshot, I was in Keepass folder and go back in parent folder 'Logiciels'.
You can see the good path in the blue bar just below tabs.

If I closed FreeCommander and restart it, I arrive in Keepass folder (I configured FreeCommander to save session and restore it)

I notice this issue occurs with network drive (provided by my Synology NAS).

It is very annoying in my FreeCommander daily use. Can you take a look on this issue?

Regards
Yann

Hello,

the problem remains in the build 740 64-bit donor.

Any chance to have a reply? What can I provide to help to fix this bug?

Youp3 wrote:Hello,

the problem remains in the build 740 64-bit donor.

Any chance to have a reply? What can I provide to help to fix this bug?

Hello,

bump, the problem remains in the build 741 64-bit.

"Tab with wrong folder name" --> confirmed for FCXE 741

I have several tabs locked.
if I am in my LAST 'Locked folder tab - no navigation' and I change my location the problem occurs

after unlocking the tab and locking it again everything's ok - for now at least

"Tab with wrong folder name" --> confirmed for FCXE 741

I see in the description from Youp3 no locked tabs.

I have several tabs locked.
if I am in my LAST 'Locked folder tab - no navigation' and I change my location the problem occurs

Please try to describe exactly what is your problem. Start with default settings and few tabs.


@Youp3: Your screenshot is broken. Have you checked your problem with default settings?

@Marek, I'm so sorry for wasting your time, there was no problem with FCXE (the problem was in front of the screen:? )
forget about my writing.
I cannot confirm the Tab with wrong folder name.

Hello Marek,

Sorry for the delay. I just reproduce the issue on new installation.

The list of parameters I modified:

• General - Allow only one instance (needs restart)
• View - File/folder list - Icons - Network (Extracted)
• View - Folder Tabs - Tab Management - Close all not locked tabs when the program ends (disabled)
• View - Folder Tabs - Tab Management - Close all tabs with UNC path when the program ends (disabled)

I open 4 tabs on left side and 3 on right side. Display is set to "Displays detail information in columns for all items" for all tabs.

On my other computer, when issue occured, there is one difference: View File/folder list - Icons - Network (Registered)

I have a question : how reset all parameters for my user? There is no option to reset configuration in the settings panel.

Regards,
Yann

Hey guys, ill noticed the same issue here with newest donor 801 build.

pOpY