FreeCommander Forum

Hi

When one of the window size is set to 0(view-split window) width it is not possible to enable quick view because the side that it would show up is collapsed. But that should not be the case in my opinion. I sometime use FC as one panel commander but when I need the quick view I need to go through couple clicking to be able to enable quick view.


thanks

You need only one doubleclick on the small line between the panes and the two panes go to 50%/50%. Or rightclick on the line and chose your preferred division.

I use shortcuts thou.

They are listed in the menu!
Use the predifined shortcuts ctrl+shift F1 (0%), ctrl+shift F2 (50%) or ctrl+shift F3 (100%) or define your own shortcuts.

yes those are the ones I use.
I should aritculate myself better. If I have one window set to %100 wide(which means I will have only one division ), I cannot acvitave quick view. Because quick view is hidden on the otherside. WHat I am trying to say is that quickview should be be shown regardless of status or size of divisions. If i have my division set to %100 on one side, when I enable quickview, quickview should just get visible by resizing invisible to normal size.