FreeCommander Forum

Hi,

currently I use the most actual stable version of FreeCommander and recognized that the drive pain is not refreshed, whenever you connect or disconnect network drives, regardsless, if this happens from the normal Explorer or within FC.

And, yes, FC is slow, when you're working on a mapped drive.

Has somebody else recognized something similar?

Regards, Thomas

Yes, Thomas, but it only happened occasionally with FC and now I can’t reproduce the problem. I did not look to see if Explorer was behaving the same way.

When I connected/disconnected any external drive FC did not show the change, even after selecting View> Refresh. At first I restarted FC each time, but them I found changing from vertical divider to horizontal and back again would shake it loose.

If the problem recurs, I will try to document it.

Hi,
well, it did not work at all for me, I had to step back to the earlier 2007 version of FC. The drive pane was never updated, only when I changed something in the options pane.

Regards, Thomas

Mr._T wrote:well, it did not work at all for me, I had to step back to the earlier 2007 version of FC.

I see the red cross, but can access the drive. I just wish it would show as mounted, I mount a couple of network drive when the machine starts, but they seem to remain supposedly unmounted until explorer has accessed them.
Martin