R532: Tree panel width is not remembered
Posted: 10.05.2011, 23:34
I am using a single tree panel on the left. I move the bar to make the panel wider, but it is reset on exit, even if I un-check auto save (and manually save once).
The FreeCommander.ini file shows:
[MainPanel]
TreePanelWidth=16
When I edit the 16 to 22 and start the program, the tree panel width is what I want. After exit, the value is reset to 16 again (with auto save disabled).
Regards, Zorkoff
The FreeCommander.ini file shows:
[MainPanel]
TreePanelWidth=16
When I edit the 16 to 22 and start the program, the tree panel width is what I want. After exit, the value is reset to 16 again (with auto save disabled).
Regards, Zorkoff