FreeCommander Forum

Hi, Sorry if this topic is already there I just did not find her, Here is the problem, both with free commander can see the resources administrator (C $, D $) as implemented in Total Commander. Thanks

I type \\servername\c$ in the DOS-Prompt field. You need to activate DOS-Prompt under Settings first.

Karol wrote:I type \\servername\c$ in the DOS-Prompt field. You need to activate DOS-Prompt under Settings first.

hello, and you can not just push something or put a tick in the settings so that he could see them without the prescription from the console, so it may even FAR (included in setup and use). Sorry for my bad english i am use on-line translation.