FreeCommander Forum

Under the

Tools > Settings > Quick search / filter / starter

there is this tab named

Quick search / quick filter

The problem with it is that whenever a user is changing something in it [or just viewing it], then after clicking either OK, Cancel or Apply and going back to

Tools > Settings > Quick search / filter / starter

what is shown is not

Tools > Settings > Quick search / filter / starter > Quick search / quick filter

but the other tab; i.e.

Tools > Settings > Quick search / filter / starter > Quick starter



This is counterproductive, because if a user is changing some settings, that user might want to re-change them back after trying them out change also some other settings available in this tab, but saving overall configuration in-between. And as other tabs available under various

Tools > Settings

sections seem to remember being picked / visited the last time, this impose behavior of the Quick starter tab must be a bug



I am using version 861 32-bit public on Windows 10 Enterprise 20H2 19042.746 x64

You are right.
It was fixed in 864.

It seems that in version 880 32-bit public FC does not remember of user going to

Tools > Settings > Quick search / filter / starter > Quick starter

as it always shows

Tools > Settings > Quick search / filter / starter > Quick search / quick filter

whenever user goes back to

Tools > Settings > Quick search / filter / starter