When switching to a remote path using ALT+g and entering the new location, an oberlay is displayed in the panel indicating the ongoing access.
Unfortunately, this pops up just after a few seconds and interrupts the legetimation dialog (to enter once credentials). This is annoying as the creadentials have to be typed in twice. If using Keepass the autotype process is also interrupted. In a worse case, the {ENTER} comming from Keepass trigers the "Cancel" (Abbruch) button which appears on the overlay and has focus at this moment. This leeds to a login without changing the path and hence the address has to be typed in again using ALT+G.
A desirable solution would be: either the overlay appears immediately before the credential dialog is shown or it might be deactivated via settings. (Perhaps there is a setting alike which I just havent found yet... )
Path change overlay takes focus and stops credentials dialog
-
- Posts: 2
- Joined: 21.02.2015, 14:21
Re: Path change overlay takes focus and stops credentials dialog
Tools > Settings > View > Drives > Select Drive > Message - only if no read?SyvUT69vnnU wrote: ↑26.04.2023, 13:51 [...]
(Perhaps there is a setting alike which I just havent found yet... )
-
- Posts: 2
- Joined: 21.02.2015, 14:21
Re: Path change overlay takes focus and stops credentials dialog
No - this is not changing the behaviour. The target window is still overlayed with the mentioned setting.
Who is online
Users browsing this forum: No registered users and 71 guests