609 - last active file/folder filter is not set at new start

Bugs and other issues or requests which have been resolved.
Post Reply
Message
Author
autocart
Posts: 28
Joined: 27.09.2011, 13:30

609 - last active file/folder filter is not set at new start

#1 Post by autocart » 07.05.2013, 10:37

The last active file/folder filter (which was set at the last active session) is not remembered at a new program start (after closing and restarting the program).
(In the "old" version of FreeCommander it is remembered without problems.)

In the bug fixes since 609 did not show this problem as fixed.

Marek
Author
Author
Posts: 3976
Joined: 10.04.2006, 09:48
Location: Germany
Contact:

Re: 609 - last active file/folder filter is not set at new s

#2 Post by Marek » 12.05.2013, 18:11

I the FC XE only reusable filters are saved and used for the new program start.

autocart
Posts: 28
Joined: 27.09.2011, 13:30

Re: 609 - last active file/folder filter is not set at new s

#3 Post by autocart » 13.05.2013, 07:20

I retested it. With just one tab on each side it seems to work fine -> the set filter is remembered and restored at the next program start.

However, when I have two tabs on the left and one tab on the right, then the set filter is not remembered/restored for the 2nd tab on the left side. (The first one on the left and the one on the right have the filter restored to them correctly.)

autocart
Posts: 28
Joined: 27.09.2011, 13:30

Re: 609 - last active file/folder filter is not set at new s

#4 Post by autocart » 17.05.2013, 08:08

Still the same, also in new version 620.

autocart
Posts: 28
Joined: 27.09.2011, 13:30

Re: 609 - last active file/folder filter is not set at new s

#5 Post by autocart » 06.06.2013, 11:23

Version 625:

It works now!! THANKS!!

Post Reply

Who is online

Users browsing this forum: No registered users and 43 guests