Page 1 of 1
724 (64 bit) - Shortcuts don't work
Posted: 09.07.2016, 17:51
by b-sonic
In FreeCommander 724 (64 bit), the shortcuts don't work any more.
It just installed it on a new system (Win 10).
When I go to the shortcuts menu, there are no shortcuts defined (e.g. F5 for copy...).
Is there any possibility to restore the known shortcuts, e.g. importing a file with all shortcuts or something like that?
Re: 724 (64 bit) - Shortcuts don't work
Posted: 09.07.2016, 18:59
by joby_toss
Editable shortcuts are saved in FreeCommander.shc file.
Re: 724 (64 bit) - Shortcuts don't work
Posted: 09.07.2016, 20:14
by b-sonic
joby_toss wrote:Editable shortcuts are saved in FreeCommander.shc file.
It would help if I had such a file with all shortcuts in it.
Re: 724 (64 bit) - Shortcuts don't work
Posted: 09.07.2016, 22:48
by joby_toss
Find where FC saves its settings (Help->About) and check if FC has the necessary rights to access that folder.
Re: 724 (64 bit) - Shortcuts don't work
Posted: 10.07.2016, 08:47
by b-sonic
joby_toss wrote:Find where FC saves its settings (Help->About) and check if FC has the necessary rights to access that folder.
FC has the rights to access that folder.
I just assigned the shortcut CTRL+F, which works now.
See the attached files (before and after assigning the shortcut).
SHC-Files.zip
Re: 724 (64 bit) - Shortcuts don't work
Posted: 10.07.2016, 10:55
by Dreamer
Try to backup settings folder, close FC, delete the FreeCommander.shc file and re-start FC, then check the shortcuts and add/change at least one, then restart FC.
Re: 724 (64 bit) - Shortcuts don't work
Posted: 10.07.2016, 13:03
by b-sonic
Dreamer wrote:Try to backup settings folder, close FC, delete the FreeCommander.shc file and re-start FC, then check the shortcuts and add/change at least one, then restart FC.
Now it works again.
And if I look into the new FreeCommander.shc file, now there is only one shortcut in the file (the one I added recently).
So maybe the problem was that there were lots of shortcuts in the file before?