Hi
When one of the window size is set to 0(view-split window) width it is not possible to enable quick view because the side that it would show up is collapsed. But that should not be the case in my opinion. I sometime use FC as one panel commander but when I need the quick view I need to go through couple clicking to be able to enable quick view.
thanks
Split window and quick view conflict
yes those are the ones I use.
I should aritculate myself better. If I have one window set to %100 wide(which means I will have only one division ), I cannot acvitave quick view. Because quick view is hidden on the otherside. WHat I am trying to say is that quickview should be be shown regardless of status or size of divisions. If i have my division set to %100 on one side, when I enable quickview, quickview should just get visible by resizing invisible to normal size.
I should aritculate myself better. If I have one window set to %100 wide(which means I will have only one division ), I cannot acvitave quick view. Because quick view is hidden on the otherside. WHat I am trying to say is that quickview should be be shown regardless of status or size of divisions. If i have my division set to %100 on one side, when I enable quickview, quickview should just get visible by resizing invisible to normal size.
Who is online
Users browsing this forum: No registered users and 178 guests