Page 1 of 1

Auto Selectable Views - Configuration

Posted: 10.12.2019, 08:16
by Odamn-Ete
Hello Marek,

among other things, it is noticeable, that you have tidied up the Auto Selectable Views. Thank you very much!

Before version 807, I only had to create a column profile and then in Auto Selectable Views use this profile for my view. Albeit, in previous version, I had to refresh in order for the view to be displayed, that is fixed now.

In version 807 I have to create two Auto Selectable Views, although the column profile being referenced is configured to include all sub folders (check box at bottom) and the condition for both the column profile as well as the Auto Selectable View is <sub>.
One for the root folder and one for all sub folders.
For root folder: X:\musik
for sub folders: X:\musik\*
If I only had an Auto Selectable View for root folder, the sub folders didn't have the same column profile as the root folder.
If I only had an Auto Selectable View for the sub folders, the root folder didn't have the same column profiles as the sub folders.

Is this the intended behavior?

best regards

FreeCommander XE 2019 Build 807 64-bit donor
Windows 10 Pro 64-bit Version 1909 Build 18363.476

Re: Auto Selectable Views - Configuration

Posted: 11.12.2019, 22:39
by Marek
If I understand, you want one auto selectable view for "x:\musik" and "x:\musik\*".
In the case define "x:\musik*"

Re: Auto Selectable Views - Configuration

Posted: 12.12.2019, 05:39
by Odamn-Ete
Marek wrote: 11.12.2019, 22:39 If I understand, you want one auto selectable view for "x:\musik" and "x:\musik\*".
In the case define "x:\musik*"
Thank you Marek!

That's exactly what I was trying to achieve and with your help it's working as I intended.