Page 1 of 1
How to change the default panel when opening FC
Posted: 01.11.2018, 17:26
by cfospam77
I have FC set up with split horizontal panes / panels. When I first open FC, the default active panel is the bottom one. How to I make the default pane / panel the top one?
Re: How to change the default panel when opening FC
Posted: 03.11.2018, 13:53
by Marek
FreeCommander activates the pane that was active when closing.
Re: How to change the default panel when opening FC
Posted: 07.11.2018, 17:26
by cfospam77
Mind doesn't to that. I tested it. I made sure the top panel / pane had the focus and then closed and reopened FC and it focused on the bottom pane again. I wonder if I have a setting somewhere that is not allowing it to keep the layout when I exit. Does a setting like that exist?
Re: How to change the default panel when opening FC
Posted: 07.11.2018, 22:05
by Marek
Have you checked the
786 release?
Re: How to change the default panel when opening FC
Posted: 07.11.2018, 22:33
by cfospam77
I was on 770 and uninstalled that and then installed 786. Still the same thing.
Windows 7 Enterprise edition Version 6.1 (Build 760.1: Service Pack 1)
Dell Latitude E8450