left panel = tree, right panel = details without tree

Discussion, questions and support.
Post Reply
Message
Author
ottenm
Posts: 20
Joined: 26.03.2008, 11:14

left panel = tree, right panel = details without tree

#1 Post by ottenm » 13.02.2015, 03:29

Hello,

I'm new to FC XE and am looking for a feature I was familiar with in 2008 FC. I used to have the left panel set to a 'tree' view, and the right panel set to a 'details' view. When I do this in FC XE, everything on the left navigates as expected. But when I switch focus to the right panel and start to navigate over there, the tree portion of the left panel follows me and updates to show where I am in the right panel. Is there a way to keep the left panel wired to that tree view and keep the right panel in details view, and have it *not* update the tree view over on the left?

Thanks for any help!


ottenm
Posts: 20
Joined: 26.03.2008, 11:14

Re: left panel = tree, right panel = details without tree

#3 Post by ottenm » 13.02.2015, 19:57

Almost! Looks like that un-wires both the left and right panels (so the tree doesn't follow either one).

Is there a way to keep the left panel wired to the tree view, so the tree follows the left panel but doesn't follow the right panel?

joby_toss
Posts: 1345
Joined: 22.07.2009, 19:19
Location: Romania
Contact:

Re: left panel = tree, right panel = details without tree

#4 Post by joby_toss » 14.02.2015, 14:26

Tools -> Settings -> View -> Tree -> General -> One tree per panel, then activate the tree (Alt+T) only for left panel.

ottenm
Posts: 20
Joined: 26.03.2008, 11:14

Re: left panel = tree, right panel = details without tree

#5 Post by ottenm » 14.02.2015, 21:30

Superb!!

Thanks you so much joby_toss! Sorry to need all the hand-holding.

Post Reply

Who is online

Users browsing this forum: No registered users and 16 guests