Slow to open .... then unable to use for 10 seconds.
Posted: 31.07.2020, 17:03
I use version "XE 2020 Build 810a 32-bit public" on a 64 bit Pro Windows 10 system.
I normally run with just one tab, the file directory tree, and one file view pane (showing details). I am not showing file/directory sizes. My system has two FLASH drives, and I have NO network. When I open Freecommander for the very first time after boot up, it takes a longgg time. Then after opening, there is another ~10 seconds before I can access any of its features.
My system's auto-defrag option is enabled.
The opening directory has perhaps 40 files, and the directlry tree has about 30 items.
I can themn close and re-open and it will be a little faster. THIS DOES NOT CONTINUE though. Later in the day I can close and re-open and ..... were back to a delay in opening.
I get the impression there is some sort of cache of information that is beign built up that becomes unbearable for the program to handle. If I knew where/what that was, I might clear it every other week.
I normally run with just one tab, the file directory tree, and one file view pane (showing details). I am not showing file/directory sizes. My system has two FLASH drives, and I have NO network. When I open Freecommander for the very first time after boot up, it takes a longgg time. Then after opening, there is another ~10 seconds before I can access any of its features.
My system's auto-defrag option is enabled.
The opening directory has perhaps 40 files, and the directlry tree has about 30 items.
I can themn close and re-open and it will be a little faster. THIS DOES NOT CONTINUE though. Later in the day I can close and re-open and ..... were back to a delay in opening.
I get the impression there is some sort of cache of information that is beign built up that becomes unbearable for the program to handle. If I knew where/what that was, I might clear it every other week.
